Back to top

Annual Bluegrass Weevil Monitoring Techniques

The Echo ES255 leaf blower converted to a vacuum shredder.
The "collecting tube", which is inserted into the end of the vacuum shredder to catch insects as they are sucked into the vacuum tube.
The two sieves that help remove extra leaf litter, branches, pine cones, and so on. The sieve on the left is 0.25 inch mesh, the sieve on the right is standard window screening. (The smaller mesh is optional, but does result in a cleaner sample to inspect.)
Attaching the screening to the dish pan.
A sieved sample with three ABW adults near the bottom (near pencil point).
Close up of the ABW adults.
Leaf litter in dish pan.
Leaf litter submerged in water and covered with paper towel.
Two ABW adults clinging to paper towel.

The annual bluegrass weevil (Listronotus maculicollis) is a significant golf course pest in many parts of the Northeast and Mid-Atlantic states.  Below is a detailed description of several monitoring techniques that can be used to track the movement of adult weevils.

1. Visual inspection

One easy approach is to get down on your hands and knees and look for adult weevils moving across the surface of the turf. This technique is not very effective when looking in overwintering sites (e.g., leaf litter under trees) and usually is not very effective when looking in the rough. It usually takes longer to conduct a visual inspection than collecting samples with a vacuum shredder (see below).

2.  Vacuum shredder (a leaf blower that has been reconfigured to suck up samples)

The vacuum shredder (which we have dubbed the "weevil sucker") is a technique that was demonstrated to Laurel Brocklesby and me while we were in New Zealand. Our host, Mark McNeill at AgResearch Lincoln, has used this approach for more than 15 years to collect weevil samples from sheep pastures. We used their vacuum several times a week while in New Zealand and were very impressed with the ability of the unit to collect adult weevils in a wide range of situations.

We are using an Echo "Vacuum Shredder", Model ES255 (See Figure 1), and have put together a prototype collecting tube to insert in the tube (Figure 2). The shredder normally shreds whatever it sucks up, but we need to preserve the insects, so we crafted a cylinder and attached the closed end of a children's butterfly net to the cylinder with duct tape. (The cylinder in the first version is a new toilet plunger, but subsequent collecting tubes will be built with a plastic cup that has been cut off at the bottom so we can attach the collecting net.)

To collect the weevils, insert the collecting tube (the netting) into the vacuum tube, start the engine, and drag it along in areas where you suspect weevils might be present. The suction is great enough that it will pull in large pine cones and twigs, along with turf, pine needles, and weevils. We typically run this unit for two minutes and then dump the contents into a sieve system (Figure 3 and Figure 4) that was built using standard dishpans, 0.25 inch mesh, and standard window screening. Place the sample in the dishpan with the coarse screen, with the finer screen beneath it. Shake the two dishpans, toss the contents gently in the air, and use your hand to rub through the coarse contents on top. Most of the weevils in that sample will fall through into the lower dishpan (the finer sieve), but they will not escape through the finer screening. (Removing the large items, such as pine cones, greatly simplifies looking at the sample.)

Place the sifted contents in a low-edged white box (or another dish pan) and look for weevils. If the air temperature is below 45, they will not be very active but if you bring them indoors, you will see them start to move quite quickly.

3.  Linear pitfall traps

Pitfall traps take advantage of insects moving in the thatch or on the surface. As they walk along, they fall into a trap that has been inserted beneath the surface. For several years, Dr. Harry Niemczyk (retired turf entomologist from The Ohio State University) has been a proponent of linear pitfall traps for monitoring ABW adult activity. The design he describes involves a 36 inch long PVC pipe that is capped at one end. Cut two slits end-to-end, each 15 inch long, along the top of the pipe with about a three inch gap between the two slits. (The slits should be 0.25 to 0.375 inch wide, big enough for the ABW adult to fall in.)

Insert the pipe in the ground such that the capped end is slightly higher than the uncapped end. Cut a hole that is the same diameter as the PVC pipe in the side of a 2-liter soda bottle. Put some sort of preservative in the soda bottle (e.g., soapy water, diluted ethyl alcohol) and cap the bottle. At the uncapped end of the PVC pipe, use a cup cutter to dig a hole, insert the bottle in the hole, and attach the open end of the PVC pipe through the hole in the bottle. Most superintendents mark both ends of the trap with flags or stakes so the area is not mowed accidentally.

Check the trap at least twice a week to determine when the weevils begin to move from their overwintering sites. (Most superintendents place the linear pitfall trap parallel to the fairway, partway between the fairway and a suspected overwintering site.)

4.  Soapy flush

Many superintendents are using a soapy flush (disclosing solution) to look for adult weevils. This technique can be quite effective on turfgrass that is managed at fairway heights and lower, but is perhaps less effective in roughs.

Mix a solution of lemon-scented liquid dish detergent and water. (Dilution rates are usually one or two tablespoons of detergent in one or two gallons of water.) Pour the solution (or apply with a watering can) to an area one to three feet on a side. Many different kinds of insects are irritated by the soapy water and wriggle to the surface. ABW adults will make their way to the surface within a couple minutes in the warm days of summer, but often take longer in the spring when air temperatures are cooler.

Some people use a pyrethrin as the irritating substance instead of lemon-scented dish detergent.

5.  Floating leaf litter

You can collect leaf litter from possible overwintering sites, bring the litter back to your office, and float out any weevils that might be present. Put the sample in a dishpan and fill the pan with enough luke warm water so the sample is fully submerged. Use forceps or tweezers or a wooden stake to stir up the sample every 10 to 15 minutes. Each time you stir the sample, put a paper towel on the surface of the water. Many weevils will be attracted to the underside of the paper towel, where they will be very easy to see. We usually leave the sample submerged for about an hour – most of the insects will float to the surface in the first 30 to 45 minutes.

Refer to the following series of monitoring photographs: